RabbitLink EG2110 Bedienungsanleitung PDF herunterladen (Seite 18)

14 RabbitLink (EG2110)

3. Configure the RabbitLink network parameters. This is done using the serial console

commands. Typing the command “show” results in a listing of the current network

addresses.

Please refer to Appendix E, “Serial Console Commands,” for a description of all the

commands. If a DHCP server was not used, the following serial console commands are

required:

set ip x.x.x.x // factory default is 10.10.1.100

set gateway x.x.x.x // factory default is 10.10.1.1

set netmask x.x.x.x // factory default is 255.255.255.0

An alternative for setting the required network addresses is to change the default values

in the RabbitLink firmware, download.c.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 57 58

Keine Kommentare

RabbitLink EG2110 Bedienungsanleitung Seite 18